Doug Blackburn
03-04-2009, 10:12 AM
When using ControlCAL's 9G NON-Elite (i.e. 5020/6020) profile... is there ONE service menu (cut/gain) memory that is applied to ALL viewing modes (i.e. Optimum, Standard, Movie, etc.)? Or is there a separate memory for each Mode?
Also, I've seen comments that the cut/offset (low luminance) control doesn't work... but it DOES work... though it only controls the 10% step. It does nothing detectable for 20% and higher. This actually works out pretty well because the gain control moves 20%-100% quite nicely (and it's already nine and uniform). 10% is the one step that often needs a touch-up to be reasonably accurate.
Also, I've seen comments that the cut/offset (low luminance) control doesn't work... but it DOES work... though it only controls the 10% step. It does nothing detectable for 20% and higher. This actually works out pretty well because the gain control moves 20%-100% quite nicely (and it's already nine and uniform). 10% is the one step that often needs a touch-up to be reasonably accurate.