Copy Settings from one ISFccc Memory to Another

[Turbe]

Thanks Turbe. Is there a way to copy ISF settings between inputs?

Hi, :hiya:

That is what the SEND ALL can be used for (ISFccc Profiles).

Basically:




Load P2.
Press START CALIBRATION.
Select Input.
Select ISFccc Memory to Copy From (isf Night, isf Day, isf Auto).
Press REFRESH.
Select Input (no need if you are going to copy from a ISFccc Memory to another on the same Input).
Select ISFccc Memory to Copy To (isf Night, isf Day, isf Auto).
Press SEND ALL.
Press SAVE.
Load P1.
Select Input (no need if you are going to copy from a ISFccc Memory to another on the same Input) - Same as Step 3 above.
Select ISFccc Memory to Copy From (isf Night, isf Day, isf Auto) - Same as Step 4 above.
Press REFRESH.
Select new Input (no need if you are going to copy from a ISFccc Memory to another on the same Input) - Same as Step 6 above.
Select ISFccc Memory to Copy To (isf Night, isf Day, isf Auto) - Same as Step 7 above.
Press SEND ALL.
Press SAVE.
Press END CALIBRATION.


NOTE: SEND ALL does not send all 9 Gamma Points, just the currently selected Point. You would need to manually update your Gamma Points (if needed).

Information on settings Gamma Controls on all 9 Points Here: http://www.controlcal.com/forum/showthread.php?p=2978&highlight=gamma#post2978

.