|
View Full Version : Jvc dla-rs1u LeBon 04-19-2009, 07:32 PM Am I missing something, or does the RS1U projector lack the necessary serial control commands to program a ControlCAL profile? I don't see any direct control commands which allow you to send a control value to the projector. Could there be other commands that are not shown in the manual? Turbe 04-24-2009, 11:00 AM Some documentation is not available publicly... You can email me what you have but I think I have docs for this model. Most Projectors have Serial Ports. LeBon 04-25-2009, 11:12 AM Some documentation is not available publicly... You can email me what you have but I think I have docs for this model. Most Projectors have Serial Ports. OK. I am also using the RS-232 port for my remote control (URC MSC-400) so I am familiar with the protocol. I have gotten the Power On and Power Off commands working from ControlCAL, so I know I am communicating with it properly. LeBon 05-18-2009, 10:38 AM JVC support tells me that "unfortunately, there are no additional control codes other than those listed in the User's Manual." It appears that ControlCAL cannot be used to control the RS-1U for calibration purposes. |