Change only the Pure Cinema Setting in an ISFccc Memory

[Turbe]

You would follow that Procedure Flow to change the Pure Cinema Control (i.e. for Input 5, isf Day):

Run ControlCAL.
Setup Serial Port Settings (first time only)
Load P2 Profile for your Display Type.


Start in Standby
Press POWER ON Button (wait until Display Powers on).
Press the START CALIBRATION Button (should now be in ISFccc Interface).
Select Input (from drop-down list) and Press SET Button next to Input Control.
Press ISF DAY MODE Button.
Press the large REFRESH Button (main ControlCAL Window next to SEND ALL) to 'get' the current settings for P2's Controls from your Display. <-- I would write these down.
Adjust Pure Cinema.
Press the small SEND Button next to the Pure Cinema Control.
Press the SAVE Button.
Press the END CALIBRATION Button.

** I think I got all the steps in there.. :rolleyes:

If you are only going to change the Pure Cinema Control, there is no need to load and use the P1 (Page 1/Part 1) Profile of the Display Profile Set.

[gorman]

Does this apply to what models? Sorry but I'm learning... :)

[Turbe]

This Procedure would work with any current ISFccc Display Profile Set for ControlCAL (and the Models that are supported with those Profiles).

:D