MarkyM
09-16-2009, 10:11 AM
Hi,
Attached below are the results of my first try at calibrating the ISF Night mode on my 500M using my new Chroma 5 meter and CalMan.
It was fun!
I haven't touched the CMS controls yet. 9-Point Gamma controls are all set to -2.
Maybe those controls are the keys to D-Nice textbook perfection??
Anyone have any ideas how I can bring the 10% level in line or am I expecting too much from my panel? (or meter?)
I wish there were "mid" controls as well as low & high because when I tried to correct the low values, bumps would appear in the middle. I assume that if you must have some error, it is better at the far ends, right?
What do you think?
Picture looks great so far!
Thanks,
--Mark--
Attached below are the results of my first try at calibrating the ISF Night mode on my 500M using my new Chroma 5 meter and CalMan.
It was fun!
I haven't touched the CMS controls yet. 9-Point Gamma controls are all set to -2.
Maybe those controls are the keys to D-Nice textbook perfection??
Anyone have any ideas how I can bring the 10% level in line or am I expecting too much from my panel? (or meter?)
I wish there were "mid" controls as well as low & high because when I tried to correct the low values, bumps would appear in the middle. I assume that if you must have some error, it is better at the far ends, right?
What do you think?
Picture looks great so far!
Thanks,
--Mark--