spongebob
02-16-2010, 09:57 AM
Does a signal need to be active on the input that is being calibrated? I read where sharpness wouldn't "stick" unless there was one.
thx
bob
thx
bob
 |
View Full Version : Signal Needed For Calibration spongebob 02-16-2010, 09:57 AM Does a signal need to be active on the input that is being calibrated? I read where sharpness wouldn't "stick" unless there was one. thx bob Turbe 02-16-2010, 11:39 AM Yes, the Monitors are finicky. If you are not doing a proper calibration using Patterns, just watch a movie or cable/sat channel. |