PRO-111FD Pure Mode Settings

[D-Nice]

Pioneer 111FD Pure Mode Settings

Picture:
AV Selection: Pure
Contrast: 37
Brightness: 0
Color: +3
Tint: 0
Sharpness: -15


Pro Adjust

Pure Cinema
Film Mode: Advance
Text Optimization: Off

Intelligence: Off


Picture Detail:
DRE Picture: Off
Black Level: Off
ACL: Off
Enhancer Mode: 1
Gamma: 2


Color Detail:
Color Temp: Manual
R High -1
G High 0
B High +4
R Low -1
G Low +1
B Low 0

CTI: Off

Color Management
R -2
Y +2
G -1
C -1
B +1
M -1

Color Space: 2


Noise Reduction:

3DNR: Off
Field NR: Off
Block NR: Off
Mosquito NR: Off

Screen Size: Full
Power Save Mode: Off
Orbiter: Mode 2


Calibration Report:
Can't view the Reports? Register to view attachments. It's free! (http://www.controlcal.com/forum/register.php)

[PioFreak]

I thought you said a rule of thumb was not to mess with Green high or green low. Also I thought that anything above 2 clicks either way in the CMS messed with the grayscale. But the calibration report looks amazing! Did you find something new out?

[D-Nice]

I thought you said a rule of thumb was not to mess with Green high or green low. Also I thought that anything above 2 clicks either way in the CMS messed with the grayscale. But the calibration report looks amazing! Did you find something new out?That rule of thumb still stands....and I've updated those settings as they were old anyway :)

[PioFreak]

By the way, thanks for your contributions and sharing of knowledge. It means a lot, especially to those of us starting out in calibration as DIY'ers for fun. Your settings are really the best that I have found on the internet and work spot on for my 5090. That proves to me there is a fundamental similarity between the NA elites and the 5090. These settings are clearly superior for me even compared to the 5090 settings floating around...go figure.

I changed a few little things ....like red high to -4 and Blue high to +2, and contrast to 38. Just "by eye" preferences until I get the 1ipro and Calman. But that may change because my bias backlight was about 5200k before, but I just installed a GAM color filter over them to pull up the color temp closer to 6500k and also reduce the light output. The filter also reduces luminosity by .5 stops. So maybe a the settings will change in some small way tonite.

Thanks again.:thumbsup:

[abax2000]

Are these settings valid for KRP-500A Pure Mode?
If not, do you know where can I look for them?

[Turbe]

Are these settings valid for KRP-500A Pure Mode?
If not, do you know where can I look for them?

No, but a Member has posted ISFccc Settings (not Pure) for the KRP-A's here: http://www.controlcal.com/forum/showthread.php?t=139

ControlCAL is used to access, activate and adjust your Display's ISFccc Interface (isf Night, isf Day, isf Auto).

Many like to use settings Posted by others but please do consider doing a proper Calibration (DIY is fine) by using a meter (Chroma 5 or I1 Pro) and additional software..... :thumbsup:

[abax2000]

thnx
Just needed a starting point and a cross reference and can't find one.