View Single Post
Unread 04-07-2015, 04:24 AM   #10
ConnecTED
Junior Member
Registered Supporter
 
Join Date: Jun 2010
Location: Athens, Greece
Posts: 21
Thanks: 0
Thanked 1 Time in 1 Post
Default

Dear disk users,

There some interesting new measurement options for HCFR users that using Ted’s LightSpace CMS Calibration Disk.

HCFR 3.1.7 (free open source calibration software) has been released and it's adding some extra measurement options for Ted's LightSpace CMS Calibration Disk of Free Version or Full Version users. For full HCFR release notes look here.

Using HCFR 3.1.7 (or later version) with Ted’s LightSpace CMS Calibration Disk Chapters that are available to the CalMAN/ChromaPure sessions of the disk, you can take measurements for the following Color Checker Patterns:

For Ted’s LightSpace CMS Calibration Disk (Free Version) users:

CalMAN’s Color Checker Classic (24 Colors)

For Ted’s LightSpace CMS Calibration Disk (Full Version) users:

CalMAN’s Color Checker Classic (24 Colors)
CalMAN’s Color Checker SG (96 Colors)
CalMAN’s Color Checker SG Fleshtones (19 Colors)
ChromaPure’s Color Checker (25 Colors)
ChromaPure’s Color Checker Skin Tones (19 Colors)

HCFR 3.1.7 follows the same pattern order with Ted’s LightSpace CMS Calibration Disk Chapters for any of the above measurement options and the HCFR’s 8-bit RGB Triplets for each pattern are matching exactly the RGB Triplets that the Ted’s LightSpace CMS Calibration disk has been encoded.

Below you can find the updated list of the total CalMAN and ChromaPure Chapters that any HCFR user can use to take measurements. These Disk Chapters are accurate and match the HCFR's Color Engine Calculations.



Instructions for x-Point Grayscale Chapters Measurements

Uncheck ''use round down levels" that is located to HCFR ‘’Preferences’’ -> ‘’General’’ Tab. This is affecting only Grayscale measurements.

Instructions for Color Checker Chapters Measurements



Before starting the measurements you have to select from HCFR's Preferences -> ''General'' Tab -> ''Color Checker Patterns'' drop down menu list the selection of the measurement run you want to perform.

Select ‘’GCD’’ if you want to measure using ChromaPure’s Color Checker Chapter.

Select ‘’ChromaPure skin tones’’ if you want to measure using ChromaPure’s Color Checker Skin Tones Chapter.

Select ‘’CalMAN Classic’’ if you want to measure using CalMAN’s Color Checker Classic Chapter.

Select ‘’CalMAN SG’’ if you want to measure using CalMAN’s Color Checker SG Chapter.

Select ‘’CalMAN SG skin tones’’ if you want to measure using CalMAN’s Color Checker SG Flesh Tones Chapter.

Note that there differences between the RGB Targets of CalMAN vs. ChromaPure ColorChecker & Skintones patterns.

Thanks Zoyd (current developer of HCFR) for adding these new features.
ConnecTED is online now   Reply With Quote